What are the rules that need attention during the operation of the surface grinder?

Surface grinding machine is mainly used to rotate the workpiece with the grinding wheel to achieve the required flatness, according to the shape of the table can be divided into rectangular table and circular table two, the main parameters of the rectangular table surface grinding machine width and length of the table, the main parameters of the circular table surface grinding machine is the diameter of the table.

Surface grinding machine in the specific operation process need to pay attention to what content? Below we introduce the next surface grinding machine 7 special need to pay attention to the structure.

1: The positioning rules of the surface grinder

Where should the machine be placed and how to install it is the best? It is understood that more than 300mm should be reserved outside the maximum movement space, each foot screw is tight, and the level before and after the table is within 0.04/1000mm. (Higher requirements for frequency converter installation)

2: Choice of grinding wheel for surface grinding machine

The selected grinding wheel must be able to withstand the turnover speed of more than 2000m/min, because if the speed is too low, it will be easy to leave traces, but the speed is too high, the price of the grinding wheel is much higher, and special attention should be paid to the use of damaged grinding wheels. If there are conditions, it is best to do the flange must be balanced after the new grinding wheel is installed.

3: surface grinding machine spindle

Before installing the grinding wheel, ensure that the spindle rotates in the clockwise direction.

4: surface grinder hydraulic device

The surface grinder uses hydraulic oil with a viscosity of 46.

The new machine needs to replace the hydraulic oil after three months of use, and then replace it once a year, while cleaning the fuel tank.

5: surface grinding machine lubrication device

The lubricating oil shall be guideway lubricating oil with viscosity No. 32. (Recommended Mevita 1 or 1405)

Confirm the oil tank (pool) level every day to ensure that it is above the line.

Check the oil circuit of guide rail every week to prevent oil loss of guide rail.

It is recommended that the tank be cleaned every three months.

Grease is filled regularly according to regulations.

6: surface grinding machine left and right mechanism

Do not adjust the left and right stroke when the table is moving.

When the workbench cable is loose, it should be adjusted immediately. (This section applies to manual models)

7: surface grinding machine flushing and dust suction device

Cleaning and maintenance of vacuum box filter, it is best to clean once every two weeks. The other is the inspection of the coolant, when the general coolant is polluted, it is necessary to check and remove in time.